Objective: Emulate a 6-Button 90’s Capcom Aracde Control Console
The goal of this project is to build an Arcade Game Console using Sanwa 30mm & 24mm buttons, Joystick, a Zero-Delay Joystick card based on Arduino Leonardo. Game system console is powered by Raspberry Pi 3+ running RetroPie.
Hadouken. Get your quarters ready. Game on!
Bill of Material:
- Sanwa Push Button, 30mm x 9
- 28mm Connector to 2-pin JST wire x 9
- Rapid Response Joystick
- Zero-Delay Joystick Encoder Board
- Box enclosure
The encoder board works perfectly on Windows system without any drivers